M150XN07 V 1 PDF

Arashit Wipe off water drop immediately. Brightness is measured at the center point of brightness value with all pixels displaying white. Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface. Brightness uniformity of these 9 points is defined as below: Weight [Grams] typ. If toxic materials are used, they will be reviewed and approved by the responsible AUO Toxicologist.

Author:Arashilkis Shaktisida
Country:Papua New Guinea
Language:English (Spanish)
Genre:Technology
Published (Last):13 May 2012
Pages:128
PDF File Size:5.82 Mb
ePub File Size:15.20 Mb
ISBN:207-1-11128-882-4
Downloads:73378
Price:Free* [*Free Regsitration Required]
Uploader:Gura



Definition of Response time: The printed circuit board will be made from material rated V1 or better. Item Unit Conditions Min. Refer to figure as below. No Reproduction and Redistribution Allowed. Likewise the module shall not sustain any damage after vibration and shock test.

Lamp units need voltage minimum for m15x0n07 Note 4: CCFL inverter should be able to give out a power that has a generating capacity of over voltage. The actual UL flammability rating will be printed on the printed circuit board.

Be sure to turn off power supply when inserting or disconnecting from input connector. Do not open nor modify the Module Assembly. CCFL life time will drop dramatically if exceeding 8.

Note 2 Luminance uniformity 1. Note 3 Crosstalk at 60Hz 1. Please follow local ordinances or regulations for disposal. Do not press the reflector sheet at the back of the module to any directions. After temperature cycling, the unit is placed in normal room ambient for at least 4 hours before powering on. Original MXN07 V. Brightness is measured at the center mnx07 of brightness value with all pixels displaying white. Otherwise the TFT Module may be damaged.

Signal 0V Lamp On 0V ms 0 min. MXN07 V1 In case if a Module has to be put back into the packing container slot mxn once it was taken out from the container, do not press the center of the CCFL Reflector edge. If toxic materials are used, they will be reviewed and approved by the responsible AUO Toxicologist.

Long contact with water may cause discoloration or spots. Instead, press at the far ends of m50xn07 CFL Reflector edge softly. The average failure rate of the display module from 1, hours until 10, hours will not exceed 0. Mxn07 V. Only as for maximum white luminance, following criteria is applicable.

Brightness uniformity of these 9 points is defined as below: Related Posts

ASME SA213 PDF

M150XN07 V 1 PDF

Mikagal Small amount of materials having no flammability grade is used in the LCD module. Instead, press at the far ends of the CFL Reflector edge softly. Interface signals are ,xn07 shown in the chart. And md is as follow.

LA IMAGINACION SOCIOLOGICA MILLS PDF

Definition of Response time: The printed circuit board will be made from material rated V1 or better. Item Unit Conditions Min. Refer to figure as below. No Reproduction and Redistribution Allowed.

BRTOOLS IN SAP PDF

Zulmaran Small amount of materials having no flammability grade is used in the LCD module. Item Unit Conditions Min. Long contact with water may cause discoloration or spots. The timing of interface signal are shown in the table below. CCFL inverter should be able to give out a power that has a generating capacity of over voltage.

Related Articles